How to reset tire pressure honda accord

Step-By-Step Instructions To Reset the Honda Tire Warning Light (TPMS) – Earnhardt Honda Blog


Your Tire Pressure Monitoring System is a valuable tool, but only if you pay attention when the Honda TPMS Warning Light comes on. When the tire light alerts you to low tire pressure – you will need to address the problem and reset the light.

Please remember that the tire pressure sensors are not a substitute for checking your tire pressure regularly. It won’t light up unless the problem is becoming serious. Underinflated tires can be a safety hazard.

Troubleshooting the Tire Pressure Monitoring System

Honda Tire Pressure Monitoring Systems vary, depending on the model type and model year.  Furthermore, TPMS systems are not uniform across the spectrum of car brands.

In addition, the technology changes from time to time, meaning that older models may not have the same capability found on new ones. Here’s some good information that may answer some of your questions about TPMS and your tire warning light.

When Does the TPMS Light Come On?

The tire pressure light isn’t required to come on until the tire is 25 percent below recommendations. Therefore, you should never ignore it. The manufacturer’s recommended air pressure is in your owner s manual.

What if the TPMS Light Came On For a Few Minutes and Turned Itself Off?

The most likely trigger is cold.  Tire pressure drops about 1 psi with every ten degree drop in cold weather.  As your tires heat up, the pressure stabilizes. That’s why there are winter and summer standards for properly inflated tires.

What if I filled the tire, but the sensor didn’t reset?

Try driving the vehicle at over 28 miles per hour for a few minutes. At that speed, the TPMS will get little or less interference from other sensors and radio frequencies. This allows it to update through the serial data bus, sending the proper tire information to the TPMS sensor.

What if I reset the TPMS light, but now it’s flashing?

According to the National Highway Traffic Safety Administration, systems may flash or stay on longer to indicate a problem with the TPMS system rather than the tire.   After checking that your tires have the proper pressure, you may need a mechanic to read the code and tell you what’s happening.

Does TPMS Read my Spare Tire?

The spare tire does not have a sensor for the TPMS system to read. The system may register nothing where the tire should be.  As long as you are confident that the spare has the correct tire pressure, it should not represent a problem.

Why Can’t I See That My Tire is Low?

Unfortunately, human eyesight cannot detect that a tire is low until the problem is really severe. .  Your manufacturer’s recommended pressure is in your owner s manual.

Can I Disconnect the Battery to Clear the TPMS Sensor?

Some people try to clear codes by disconnecting the battery. Generally the system saves all codes and doesn’t reset them just because the battery is removed.  This is actually a fail-safe feature because mechanics need those codes to determine what is wrong with a vehicle.

What if I clear the code before my mechanic has a chance to read it?

If you are able to clear the TPMS code, you will be overwriting it with a new code.   Unless the system triggers the sensor again, your mechanic will not find the important code.

Why is Tire Pressure So Important?

According to the automotive journalists at Edmunds, a mere 5 PSI can cause a tire to fail. An underinflated tire generates heat as it struggles to keep up with the job it has to do.  This causes faster degeneration.

Furthermore, an underinflated tire affects the accuracy of steering and handling. Thus, the vehicle declines in performance and fuel economy.

What is Direct vs. Indirect TPMS?

Direct TPM sensors are attached to the valve for the most accurate reading. With indirect TPMS, the anti-lock brake system assists in determining approximate pressure. Although a good system, it is not as fast as a direct system.

Does My Old Car NOT Have Tire Pressure Monitoring?

Starting with the 2008 model year, every Honda has TPMS. All cars made before the 2018 probably don’t have this feature.

If you don’t have a light to turn on and warning you, it’s all the more important to carry a gauge to check and add air as needed. Explore the Earnhardt Honda inventory today to find a Honda car, truck or crossover with TPMS!

How To Reset the Honda Tire Pressure Monitoring System TPMS Warning Light

Learn how to reset the tire warning light with this step-by-step guide and get back to normal. Instructions To Reset the Honda TPMS Warning Light

  • Check the Tire Pressure in All Tires
  • Fill With Air or Replace Tires as Needed
  • Keep Your Honda in Park and Start the Vehicle
  • Find the Honda TPMS Button to the Left of the Steering Column
    • Press and Hold Until the TPMS Warning Light Blinks Twice
    • Honda TPMS Will Begin to Re-Calibrate
  • If There is No TPMS Button – Select Vehicle Settings on the MID Screen
    • Press the Select/Reset Button
    • Select TPMS Calibration
    • Select Calibrate

Posted in Features, Model Information, Service, Tips and Tricks | No Comments »

How To Reset Tire Pressure Light On Honda Accord & CR-V?

Updated on

Tire pressure is one of the most important aspects of vehicle safety and keeping it in check can prevent costly repairs and even save lives.  

With the advent of Tire Pressure Monitoring Systems (TPMS), it has become easier than ever to monitor your vehicle’s tire pressure. 

However, sometimes TPMS can malfunction, causing false alarms or failing to detect actual issues. In such cases, knowing how to reset your Honda’s TPMS can come in handy.

Before the TPMS will work properly again, it must be recalibrated whenever your tires are reinflated, changed, or rotated.

In order to recalibrate, you must drive between 30-65 miles per hour for about 30 minutes. When this happens, it will automatically stop, and you will be able to monitor tire pressure.

Honda Accord & CR-V Tire Pressure Monitoring Systems (TPMS) Reset

Does your Honda vehicle need its tire pressure monitoring system (TPMS) reset? Depending on what kind of technology is installed in your Honda and when you bought it, the instructions may differ. You can find your car’s instructions below.

TPMS Reset In Older Honda Vehicles
For Models With A TPMS Button

There is a TPMS button located on the left side of the steering wheel if your vehicle is equipped with one. The warning light should blink twice when you hold down the button.

For Models Without The Touchscreen Display

The Driver Information display can be accessed and used by using the steering wheel:

  • Select SETTINGS from the vehicle’s screen
  • Calibration of the TPMS should be selected
  • Choose Calibrate
For Models With Steering Wheel Controls
  • Click the MENU button
  • Choose Customize Settings from the menu
  • Select the calibration method for your TPMS
  • Select the initialize option
  • Check the YES box
  • To exit, press the MENU key

How To Reset Tire Pressure Monitoring System In Newer Honda Vehicles
Models Without The Touchscreen Display

Entering selections in the Driver Information display using the steering wheel buttons:

  • Select the Settings screen on the vehicle’s screen
  • Select the calibration method for your TPMS
  • Choose Calibrate
Models With Display Audio Touchscreen
  • Select Settings from the home screen
  • Choose a vehicle
  • Select TPMS calibration
  • Calibrate should be selected

What Causes The TPMS Light To Come On?
  • The tires are compact.
  • Mixed tire types and sizes. It is important to use tires of the same size and make
  • As compared to when calibrated, the tires are loaded heavier and unevenly.
  • Roads that are slippery or snowy.
  • The system can be triggered by low ambient temperatures, for example.
  • It is not calibrated yet. It usually takes 30 minutes of cumulative driving at speeds ranging from 30-60mph (48-97km/h)
  • During calibration, the light may come on briefly if the ignition is turned on and the vehicle doesn’t move within 45 seconds. In this case, the process hasn’t been completed yet.

Final Words

Your vehicle’s TPMS may be malfunctioning if the warning light flashes every time you start it.

You might experience this if a tire or wheel has been incorrectly installed – stop by a Honda service center and they’ll find the problem and fix it!

Filed Under: Honda Accord

About Todd DeLong

As an experienced Engineering Coordinator at Honda America Manufacturing East Liberty Auto Plant, I am passionate about providing excellent customer service and technical support to the plant's engineering staff. I have a strong background in industrial engineering and a commitment to excellence that has enabled me to successfully manage the day-to-day operations of the engineering department.
My expertise includes managing projects, developing technical documents, and providing training and guidance to staff members.LinkedIn

Reader Interactions

How to reset the tire pressure sensor Honda Accord?

You are the proud owner of a recent car, the benefits of tactile gadgets, the integrated technologies should bring you a significant usability of your Honda Accord, however, it says that the technology is talking about electronic, and as we all unfortunately know , in some cases problems that need to be fixed. Today we will focus on the tire pressure sensor and specifically on the tire pressure sensor. how to reset the tire pressure sensor on a Honda Accord so that this indicator never appears on the dashboard again. In order to achieve this, we will divide our article into two parts: first we will focus on the classic situation where the tire pressure indicator light occurs and the subsequent process, and then on the circumstance that the tire pressure indicator remains on even if the tires are inflated. So how to reset this tire sensor on honda accord.

How to reset the tire pressure sensor on a Honda Accord? Checking tire pressure

First, we will focus on the classic way to reset a tire sensor on a Honda Accord, which if it lights up, here are the basic tricks: tire pressure indicators on your Honda Accord, get out of the way immediately if you are driving on the highway, keep a firm grip on the steering wheel just in case.

  • Once stopped, visually check the condition of your tires , if one of them is completely flattened, replace the wheel, if it is only under-inflated, go carefully to the gas station.
  • Check the tire pressure of your Honda Accord with a pressure gauge and follow the manufacturer's recommendations. on a sticker in the driver's door.
  • If you find during this re-inflation that the tire is damaged, it is replaced0003 The logical process of how to reset the tire pressure sensor on a Honda Accord. The indicator light should have gone out or gone out after a few seconds. . If this is not the case, we advise you to go through the next section.
  • How to reset the Honda Accord tire pressure sensor that stays on when the tire pressure is high

    Reset the Honda Accord tire pressure sensor

    Now that you have tried the normal process of removing the tire pressure sensor on the Honda Accord, and this didn't work, we'll move on to the second alternative, which is to have the tires on my Honda Accord well inflated and I still want that light to go out. This almost certainly means you have Faulty tire pressure sensor. For this important reset the value on the dashboard of your car. However, be careful not to do this while driving as pressure fluctuations will interfere with your sensors. In most cases, you need to go through the car configurations, then you should find an option for inflation detection or "deflation detection". While on this tab, you must hold down the Select or Reset button, depending on the year of your Honda Accord, until a message appears from the car console confirming that the reset is being taken into account (usually takes a few seconds). You can now turn off the ignition and restart your Honda Accord to see if the tire pressure light has gone out.

    Optional Solution to Reset Tire Pressure Sensor on Honda Accord: Replace Faulty Tire Pressure Sensor almost certainly

    Tire pressure sensor on the valve which is defective or faulty on your Honda Accord . Keep in mind that usually the unit price is around 120 euros. Another solution that some people prefer to do, since the problems may recur in some series, is to deactivate the sensors with the help of your carrier and diagnose your vehicle. However, this procedure is not recommended as it may result in improper handling and malfunction of your Honda Accord. Now you have all the keys in your hands to know how to reset the tire pressure sensor on your Honda Accord.

    If you have any further questions about the Honda Accord, do not hesitate to contact us. Honda Accord category.

    How to reset tire warning light on Honda Accord?


    Frequently asked questions about cars and motorcycles
    1. by car
    2. :
    3. Honda
    4. :
    5. Accord
    6. : How to reset tire warning light on Honda Accord?

    Honda Accord - Video Lesson

    Model: Honda Accord MK 9 - Years 2012-2017
    Part: inspection and maintenance
    operation: How to reset the tire warning light on a Honda Accord?

    As we can see in this guide, resetting a tire warning light in a Honda Accord is a very simple operation. This procedure should only be performed after the correct pressure has been restored to each tire, for example after a puncture. Let's start by inserting the key and turning on the dashboard, then find the button pointing to the light itself, located on the lower left side of the dashboard. Then keep it pressed for about 3 seconds, or in any case, for the time it takes for the light to flash and then disappear completely. Finally, let's restart the picture.

    Published 26 April 2022 by ScegliAuto

    Installation of luggage racks.

    The car is already equipped with a luggage rack, so you need to purchase the right luggage rails for your car model. The first step is to remove the eight plastic plugs hiding the threaded nut. Position the two beams on the roof according to the mounting holes, then tighten the eight mounting screws without tightening them.

    Learn more