Your Tire Pressure Monitoring System is a valuable tool, but only if you pay attention when the Honda TPMS Warning Light comes on. When the tire light alerts you to low tire pressure – you will need to address the problem and reset the light.
Please remember that the tire pressure sensors are not a substitute for checking your tire pressure regularly. It won’t light up unless the problem is becoming serious. Underinflated tires can be a safety hazard.
Honda Tire Pressure Monitoring Systems vary, depending on the model type and model year. Furthermore, TPMS systems are not uniform across the spectrum of car brands.
In addition, the technology changes from time to time, meaning that older models may not have the same capability found on new ones. Here’s some good information that may answer some of your questions about TPMS and your tire warning light.
The tire pressure light isn’t required to come on until the tire is 25 percent below recommendations. Therefore, you should never ignore it. The manufacturer’s recommended air pressure is in your owner s manual.
The most likely trigger is cold. Tire pressure drops about 1 psi with every ten degree drop in cold weather. As your tires heat up, the pressure stabilizes. That’s why there are winter and summer standards for properly inflated tires.
Try driving the vehicle at over 28 miles per hour for a few minutes. At that speed, the TPMS will get little or less interference from other sensors and radio frequencies. This allows it to update through the serial data bus, sending the proper tire information to the TPMS sensor.
According to the National Highway Traffic Safety Administration, systems may flash or stay on longer to indicate a problem with the TPMS system rather than the tire.
After checking that your tires have the proper pressure, you may need a mechanic to read the code and tell you what’s happening.
The spare tire does not have a sensor for the TPMS system to read. The system may register nothing where the tire should be. As long as you are confident that the spare has the correct tire pressure, it should not represent a problem.
Unfortunately, human eyesight cannot detect that a tire is low until the problem is really severe. . Your manufacturer’s recommended pressure is in your owner s manual.
Some people try to clear codes by disconnecting the battery. Generally the system saves all codes and doesn’t reset them just because the battery is removed. This is actually a fail-safe feature because mechanics need those codes to determine what is wrong with a vehicle.
If you are able to clear the TPMS code, you will be overwriting it with a new code.
Unless the system triggers the sensor again, your mechanic will not find the important code.
According to the automotive journalists at Edmunds, a mere 5 PSI can cause a tire to fail. An underinflated tire generates heat as it struggles to keep up with the job it has to do. This causes faster degeneration.
Furthermore, an underinflated tire affects the accuracy of steering and handling. Thus, the vehicle declines in performance and fuel economy.
Direct TPM sensors are attached to the valve for the most accurate reading. With indirect TPMS, the anti-lock brake system assists in determining approximate pressure. Although a good system, it is not as fast as a direct system.
Starting with the 2008 model year, every Honda has TPMS. All cars made before the 2018 probably don’t have this feature.
If you don’t have a light to turn on and warning you, it’s all the more important to carry a gauge to check and add air as needed.
Explore the Earnhardt Honda inventory today to find a Honda car, truck or crossover with TPMS!
Learn how to reset the tire warning light with this step-by-step guide and get back to normal. Instructions To Reset the Honda TPMS Warning Light
Posted in Features, Model Information, Service, Tips and Tricks | No Comments »
I have a 2018 Honda Civic EX.
I recently put some air in the tires because the low tire pressure light came on. But even after filling the tires to the specifications in the owner’s manual, the light remains lit. How can I turn off the tire pressure warning on my 2018 Civic?
Eric Schad · Answered on Dec 28, 2021
Reviewed by Shannon Martin, Licensed Insurance Agent.
Proper tire pressure is essential to your safety when you’re behind the wheel of your Honda Civic EX. However, the tire pressure monitoring system (TPMS) doesn’t always reset after you fill the tires.
To reset the low tire pressure light on a 2018 Honda Civic, follow these steps:
In less than a minute, you’ve fixed your low tire pressure light. Did you know in the same amount of time you can save hundreds of dollars on your car insurance?
Just download the Jerry app, answer a few quick questions, and in about a minute, you’ll get low-cost quotes from name-brand insurance companies. Users save an average of nearly $900 per year!
MORE: Will insurance cover a flat tire?
HondaCar MaintenanceCar Technology
WHY YOU CAN TRUST JERRY
Jerry partners with more than 50 insurance companies, but our content is independently researched, written, and fact-checked by our team of editors and agents. We aren’t paid for reviews or other content.
Browse More Content
Fuel Pump Replacement
Car Heater is Not Working: Inspection Cost
What To Do If Your Power Seat Is Not Working
What To Do If You're Not Able To Change Gears
Car Shift Inspection
Cheap Car Insurance in Delaware
Cheap Car Insurance in Arizona
Cheap Car Insurance in California
Cheap Car Insurance in Oregon
Cheap Car Insurance in South Dakota
I just got an oil change on my 2007 Honda Accord LX and it’s running great.
The only problem is the oil life indicator still reads 30%. How can I reset the oil light on my 2007 Honda Accord?
Eric Schad
Dec 28, 2021
I just got a new BMW and I’m not sure if my insurance automatically switches to my new car, or if there’s something I need to do. How do I switch insurance to my new car?
Chloe Jenkins
Dec 28, 2021
Is there a way to reset the tire pressure on my 2018 Civic? I just refilled my tires but it’s still saying that my tire pressure is low, so I think the system just didn’t reset properly.
Liz Jenson
Dec 28, 2021
Browse All Questions
Not sure how much oil to put in your 2010 Dodge Journey? We’ll tell you all about it and give you some maintenance advice, too.
Zachary Morgan
Aug 22, 2022
Don’t know where to find your 2013 Ford Explorer engine oil capacity? We have the information you need.
Zachary Morgan
Jul 20, 2022
Depending on your credit score, down payment, and lease term, you can expect to pay between $400 and $600 per month on a Jeep Cherokee Limited lease.
Zachary Morgan
Jan 01, 2019
Car Warranties
Car Transport
Valuable Articles Insurance
Insurance Shopping
Pickup Trucks
Bundling
Grundy Classic Car Insurance
Car Liens
Add a Driver
Acts of God
The General
Rental Discounts
International Drivers
Non-Owner
Hippo Insurance
High Risk Auto Insurance
Fleet Sales
Mercedes
Car Leasing
Car Dents
Florida
New Cars
Recalls
Car Loan
Non Owner Car Insurance
Wawanesa
Moving Violations
Car Accidents
No long forms
No spam or unwanted phone calls
Quotes from top insurance companies
Find insurance savings — it's 100% free
Car Insurance
Cheap Car Insurance
Car Insurance Quotes Online
Types of Insurance
Toyota
Hyundai
Mercedes-Benz
Subaru
Chevrolet
Mitsubishi
ALAKAZARCACOCTDEFLGAHIIDILINIAKSKYLAMEMDMAMIMNMSMOMTNENVNHNJNMNYNCNDOHOKORPARISCSDTNTXUTVTVAWAWVWIWY
Honda Tire Pressure Monitoring System (TPMS) has its own specifics when programming new sensors, data registration and calibration.
But with basic knowledge, servicing Honda TPMS systems is easy.
Honda's direct TPMS systems with pressure sensors in each wheel are difficult to compare with other vehicles using the same type of TPMS as they require special hardware to connect via the OBD II connector and the procedures are similar. However, there are exceptions, such as Honda Pilot (automatic programming of the system) and vehicles using indirect TPMS systems that use the ABS readings in operation, the difference in wheel speed depending on pressure, i.e. there are no pressure sensors in the system, for example, Honda Civic, Accord, other models after 2012 of release.
Most specialized TPMS service tools can activate the sensors to receive an identification signal from the sensor and their position in the vehicle. The information is then fed through the OBD II connector to the TPMS module. Programming is carried out using a scanner. For Honda's direct TPMS systems, 45 km/h is the magic number. After the vehicle has reached a speed of 45 km/h and has been driven for at least a minute, the system acknowledges the sensor signals, identifies them and captures the pressure information.
Speed is not detected by sensors, speed is determined via CAN bus and TPMS module. Honda engineers believe that at this speed the system is less susceptible to interference from other sensors and radio frequencies.
If a vehicle arrives at the garage with the TPMS warning light on, inflate the tires to the prescribed pressure and drive the vehicle at 45 km/h for one minute. The low system pressure indicator should turn off. 45 km/h - the speed of movement for each procedure of reprogramming the system and registration of data. For indirect type systems, there are other magic numbers - driving at a speed of 65 - 95 km / h for 20 minutes. The initialization process occurs by pressing the TPMS reset button on the instrument panel or steering wheel.
Hondas with direct systems typically have two TPMS lights on the instrument panel. One ISO standard indicator for low tire pressure, another TPMS MIL indicator. In the event of a malfunction in the TPMS system, the module displays a fault code, but goes into safe mode.
The system does not notify the driver of a dangerous low tire pressure. In the event of a malfunction, the TPMS system generates indicator flashes every 30-90 seconds and the flash cycle repeats. A working system signals one signal that lights up for a couple of seconds, then the indicator goes out.
The TPMS fault code is stored in non-volatile memory and cannot be cleared by disconnecting the cable from the battery. To erase the fault code, you must use a scanner. The system memory may contain all the TPMS trouble codes that may occur. But, if the same code occurs twice or more, in most cases the subsequent code is overwritten with the previous one, thus saving each last of the TPMS system fault codes.
When a flat tire is replaced with a spare in a direct type system, the TPMS sets DTCs 32, 34, 36, 38 because the system no longer receives a signal from the flat tire sensor.
Honda TPMS indirect type does not include wheel pressure sensors.
The system determines the reduction in tire pressure by comparing the relative speed of rotation of the wheels through the ABS wheel sensors. When the tire pressure is reduced, the wheel diameter is slightly reduced. This type of system has been installed on the Honda Accord since 2013. Recalibration must be carried out in the event of a change in tire pressure or adjustment to normal. The process does not require the use of special tools, it is carried out using the TPMS reset button located under the steering wheel or a combination of pressing the information center button, or the button located on the steering wheel.
1. Make sure the vehicle transmission is in neutral or park.
2. Check all wheel dimensions and type.
3. Set the correct tire pressure.
4. Switch on the ignition.
Press and hold the TPMS button located on the lower left of the instrument panel until the TPMS low tire pressure indicator flashes twice.
If the indicator does not flash, press and hold the button again. Recalibration will be completed after running for 20 minutes at 65-95 km/h
1. Using the monitor and steering wheel controls, select Vehicle Settings, press the SEL/RESET button. The calibration process will start.
2. The display will switch to setting mode when you select, cancel or calibrate.
3. Select Calibration, then press the SEL/RESET button. If the process has started, the monitor will display Calibration Started. If the message Calibration Failed to Start appears, repeat steps 2 and 3. Recalibration will be completed after running for 20 minutes at a speed of 65-95 km/h
1. Use the monitor and steering wheel controls, press Menu/MENU and go to Vehicle Menu
2. Select Customized Settings and press the SOURCE button.
3. Select TPMS Calibration, then press the SOURCE button.
The display will switch to the settings menu when you select between Cancel or Initialize/Apply. If the calibration is completed the TMPS will return to the settings menu. If you see an inscription about the impossibility of initializing the TPMS system, repeat steps 2 and 3. Recalibration will be completed after running for 20 minutes at a speed of 65-95 km/h
Subscribe to Articles and Newsletters
Get full access Buy Autodata
You are the proud owner of a recent car, the benefits of tactile gadgets, the integrated technologies should bring you a significant usability of your Honda Accord, however, it says that the technology is talking about electronic, and as we all unfortunately know , in some cases problems that need to be fixed. Today we will focus on the tire pressure sensor and specifically on the tire pressure sensor. how to reset the tire pressure sensor on a Honda Accord so that this indicator never appears on the dashboard again.
To achieve this, we will divide our article into two parts: first we will focus on the classic situation where the tire pressure indicator light occurs and the subsequent process, and then on the circumstance that the tire pressure indicator remains on even if the tires are inflated. So how to reset this tire sensor on honda accord.
First, we will concentrate on the classic way to reset a tire sensor on a Honda Accord which, if it lights up, here are the basic tricks: your Honda Accord tire pressure indicators, get out of the way immediately if you are driving on the highway, keep a firm grip on the steering wheel just in case.
on a sticker in the driver's door. Now that you have tried the normal process of removing the tire pressure sensor on the Honda Accord, and this didn't work, we'll move on to the second alternative, which is to have the tires on my Honda Accord well inflated and I still want that light to go out. This almost certainly means you have Faulty tire pressure sensor. For this important reset the value on the dashboard of your car. However, be careful not to do this while driving as pressure fluctuations will interfere with your sensors.
In most cases, you need to go through the car configurations, then you should find an option for inflation detection or "deflation detection". While on this tab, you must hold down the Select or Reset button, depending on the year of your Honda Accord, until a message appears from the car console confirming that the reset is being taken into account (usually takes a few seconds). You can now turn off the ignition and restart your Honda Accord to see if the tire pressure light has gone out.
